Consultancy
Consultancy Services
Four areas, one approach: independent, fixed-fee, with a defined input and a defined output on every piece of work. Pick the area closest to you — each page breaks it down into specific capabilities.
Product Design & DFM
You have a part design — or you're mid-design — and need to know if it's mouldable, what it will cost to tool, and what could go wrong before steel is cut. We'll save you an expensive redesign.
4 capabilities →Injection Moulding
You have a press, operators, and tools. The problems are usually process instability, a difficult new job, a quality issue you can't pin down, or a customer pushing for validation you haven't done before. We've seen all of it.
5 capabilities →Tooling & Mould Design
You design and build tools, often with minimal upfront input from the customer. The pain points are DFM disputes, steel-safe strategy, and underquoting because the complexity wasn't spotted early. RFT Moulding can be your technical backstop.
4 capabilities →Pharma / Medical / CMO
You have a plastic component or device to manufacture, usually through a contract moulder. You understand regulatory requirements but need someone who speaks both languages — moulding process and validation. That's where we fit.
5 capabilities →Engagement Models
How the commercial side works — from a single Technical Review through to embedded contract support.
See the full ladder →