Tooling & Mould Design
You design and build tools, often with minimal upfront input from the customer. The pain points are DFM disputes, steel-safe strategy, and underquoting because the complexity wasn't spotted early. RFT Moulding can be your technical backstop.
Tool Design Review
Written review of your 2D/3D tool design at concept or detail stage: cooling, venting, gating, ejection, steel-safe strategy, and risk flags.
You send
2D or 3D tool design
Part drawing + material
You receive
Written review report
Risk flags + recommendations
DFM Consultation
Pre-steel recommendations on wall stock, draft, and feature risks. Gives you a defensible technical position with your customer if disputes arise.
You send
Part drawing
Proposed tool concept
You receive
DFM recommendations
Written before steel is cut
Steel Safe / Tuning Strategy
Dimensional analysis and recommended steel-safe allowances with a tuning sequence — so you cut steel once and tune to tolerance.
You send
Part drawing
Material + target tolerances
You receive
Steel safe allowances
Tuning sequence document
Quotation Support
Technical risk assessment to support accurate quoting — identifies complexity, hidden risk, and scope that affects your cost before you commit.
You send
Part drawing
Customer requirements
You receive
Technical risk assessment
Complexity flags